Hi,
Not sure if anyone will know what i'm on about, but if you have ever removed the drivers seat (maybe passenger seat too) from the rail assembly, there are a bunch of oval washers.
These washers allow the screws to attach the seat to the rails tightly whilst still allowing the seat height to be adjusted.
Mine have all exploded.
If anyone is scrapping a tatty seat and fancies finding these washers for me (just undo 4 nuts and bolts), or happen to have these lying around then that would be most helpful. I haven't tried volvo yet. I think it would be even harder to explain and I may have to install the tardis software again...
Thanks,
pol
Wanted: Funny washers for drivers seat
Moderators: jifflemon, coyote1980, Rachel
- glasgowjim
- 480 Is my middle name
- Posts: 4830
- Joined: Sun Oct 01, 2006 5:28 pm
- Location: GLASGOW SCOTLAND
Re: Wanted: Funny washers for drivers seat
Pol know exactly what you mean
the washers you refer to (there are 4 of them) are on the front two "sliders" only two per side and they will disintegrate in time. However as an interim measure just use large circular washers. The back two standard washers will do the trick.
0 this is the shape.
the washers you refer to (there are 4 of them) are on the front two "sliders" only two per side and they will disintegrate in time. However as an interim measure just use large circular washers. The back two standard washers will do the trick.
0 this is the shape.
Re: Wanted: Funny washers for drivers seat
Thought you might know Jim! But do you have any, that is the question?!
I have used washers but it kind of locks the seat in one position. If it is not done up so tight then it rocks around.
Must dig out the tardis CD...
Thanks,
pol
I have used washers but it kind of locks the seat in one position. If it is not done up so tight then it rocks around.
Must dig out the tardis CD...
Thanks,
pol