Volvo 480 Club Europe

Anyone with a spares for the plastic cover of the coat hangers? Anyone doing repros?

I'd also be interested. Have considered a big bit of heat shrink but never actually done anything about it.

I looked at making repro’s but it’s the material that’s the problem. It’s a soft rubber.
I’ve some links for someone who did a variety of it, rather than a reproduction. Can dig them out if you want?

Edit: link as promised

Hi
Maybe have ori sets , must check .
regards
Marek

Lucky you
Have 4 sets , ori Volvo , / screw , hanger , cover / , 1 set = 12 GBP + registered letter .
regards

malkontent wrote: ↑

Sun Mar 24, 2024 6:44 pm

Lucky you
Have 4 sets , ori Volvo , / screw , hanger , cover / , 1 set = 12 GBP + registered letter .
regards

PM Sent !

PM replied. Thanks a lot Marek!

Should be reproduced though. I have no experience with molding and silicone and stuff, but would take 2 sets just to send it out to someone with reproduction skills

To make it clear :

This is one set for one side !

balto8 wrote: ↑

Sun Mar 24, 2024 9:20 pm

PM replied. Thanks a lot Marek!

Should be reproduced though. I have no experience with molding and silicone and stuff, but would take 2 sets just to send it out to someone with reproduction skills

As Jeff linked to the hard plastic part is a doddle to print in 3D but the 'soft part' is a bummer as the lip will cause issues?

maybe an alternative is to print a modified hard part to take a screw with a cover as used for DIY like these?

https://www.screwfix.com/c/screws-nails ... /cat840002 (other suppliers are possible)

if the rigid part is printed in matching black, job done, or make a 3D plastic cap in grey? but only uses a tiny bit of filament to make a cap!

Marek. I have PMd you. Please contact me for 2 sets

So Marek sets were sold out to someone else. Anyone else out there?

maybe later ,watch me .

I have found a single spare rubber cap in my screw box if anyone needs one...