This is an important part if it is working nicely.....mine gets worst day by day...
My query is the following....does anybody know what are the proper OHM (resistance) figures for this device???
What is the procedure for changing the ohm values??? except the screw on the right hand side is something more to look???
please advise
1. my idle regulator valve is cleaned (volvofox threads)
2. temp sensor is new
3.when cold the idle is fine...when gets hotter 60 c gets worst....
4.injectors are cleaned
sakis480
Air mass flow meter
Moderators: jifflemon, coyote1980, Rachel
- volvofox
- 480 Is my middle name
- Posts: 2034
- Joined: Sun Jan 19, 2003 2:18 pm
- Location: Born, Netherlands
- Contact:
Check for leaks. I know a 480 who leaks vacuum through the brake servo"brake enforcer" it runns very bad too.
Maybe you as a "mediteranian" can speak french. I saw some thread (my french is not good) about what looked like exactly the answer to your question.(other wise try a translation site)
Now I should not advice you to go somewhere else, but maybe this helps your longlasting trouble. Please come back
http://www.volvo480.org/phpBB/viewtopic ... sc&start=0
luck
JPF
Maybe you as a "mediteranian" can speak french. I saw some thread (my french is not good) about what looked like exactly the answer to your question.(other wise try a translation site)
Now I should not advice you to go somewhere else, but maybe this helps your longlasting trouble. Please come back
http://www.volvo480.org/phpBB/viewtopic ... sc&start=0
luck
JPF
luck,
JPF
Nomen est Omen
JPF
Nomen est Omen